Selector Fork Overview

Selector Fork Overview

• The selector fork group (- item 7 -) does not need to be disassembled to remove and install the shift segments, lock washers and ball bearings.






1 5th Gear Shift Segment

• Identification, refer to => [ Shift Segment Identification ] Shift Forks.

• The shift segment must still rotate easily after the lock washer is installed.

2 Lock Washer

• Always replace.

• Removing, refer to => [ Removing the Lock Washer ] Shift Forks.

• Installing, refer to => [ Installing the Lock Washer ] Shift Forks.

3 5th Gear Selector Fork

• Adjusting, refer to => [ Adjusting the 5th Gear ] Transmission.

4 Bolt

• 25 Nm

5 5th Gear Shift Jaw

6 Ball Bearing

• Quantity: 4

• Removing, refer to => [ Removing the Ball Bearings ] Shift Forks.

• Pressing the bearing inner race into the outer race. Refer to => [ Installing the Ball Bearing Inner Race into the Outer Race ] Shift Forks.

• Installing, refer to => [ Installing the Ball Bearing into the Selector Fork ] Shift Forks.

7 Selector Fork with Rail

8 1st/2nd Gear Shift Segment

• Identification, refer to => [ Shift Segment Identification ] Shift Forks.

• The shift segment must still rotate easily after the lock washer is installed

9 3rd/4th Gear Shift Segment

• Identification => [ Shift Segment Identification ] Shift Forks.

• The shift segment must still rotate easily after the lock washer is installed.

10 Gliding Piece

11 Spring

12 Reverse Gear Selector Fork

13 Support for the Reverse Gear Selector Fork

14 Lock Ring