Back Window Motor: Service and Repair

Rear Window Regulator Motor

• The following describes removing and installing the left window regulator motor. Removing and installing the right window regulator motor is identical.

Removing






- Remove the rear door trim panel.

- Secure the door window with adhesive tape to prevent it from falling down.

• Turn off the ignition and all electrical equipment.

• Remove the key.

- Disconnect the connector - 3 -.

- Remove the 3 bolts - 2 -.

- Remove the window regulator motor and control module - 1 - from the mounts on the cable reel.

Installation

It is necessary to code the additional functions and pinch protection each time a new window regulator motor (door control module) is installed.






- Install the window regulator motor - 1 - on the mounts in the cable reel. Gently move the door window up and down so that the splines between the window regulator motor and the cable reel can mesh.

- Install the 3 bolts - 2 -.

Tightening specification - 2 -: 3 Nm

- Connect the connector - 3 -.

- Code the new window regulator motor using the Vehicle Diagnosis, Testing and Information System (VAS 5051B).

Install in reverse order of removal.