Lock Carrier

Lock Carrier with Attachments

• The lock carrier is a safety-relevant component and for this reason it may not be serviced.

• If damaged, replace the lock carrier.






- Bring the lock carrier and its attachments into the service position - 1 -. Refer to => [ Service Position, Setting ] Service Position, Setting.

- Disconnect the electrical harness connectors present.

- Disconnect the connector for the crash sensor.

- Drain the coolant and disconnect coolant line.

- Disconnect condenser lines.

- With a second technician, remove guide rod (T 10093) on longitudinal member on left and right sides and lift out lock carrier.

Do not start the engine whenever the A/C system or coolant lines are disconnected.

• Do not hang the condenser and hydraulic oil cooler by the lines.

• Do not kink the condenser and hydraulic lines.

Installation

Install in reverse order of removal.

• Make sure that all plug- and hose connections are corrected installed when re-assembling.

• The angle brackets on the longitudinal member must be installed. Refer to => [ Bumper Angle Brackets Assembly Overview ] Bumper Angle Brackets Assembly Overview

- For bolt tightening specifications, refer to the Assembly Overview. Refer to => [ Lock Carrier Assembly Overview ] Lock Carrier Assembly Overview

- Align the lock carrier with the longitudinal members and between the fenders.

- Secure the headlamp and check the headlamp setting.