Rear Glass Panel

Rear Glass Panel

• When removing the screws, use a magnetic tool so that the screws cannot fall into the guide for the panorama sunroof mechanism.

- Push knob beyond comfort setting to completely open the front glass panel.

- Remove the screws - 3 - of the rear glass panel - 1 -.






- Remove the spacer - 2 - under the glass panel.

- Drive the front glass panel into the "tilted" position.

- Gently pull the inner seal - 3 - inward at the marked locations - arrow - and remove the screws - 2 -.






- Lift out the rear glass panel - 1 -.

Installation

Install in reverse order of removal.

• New screws are to be used when installing the glass panel.

• When removing the screws, use a magnetic tool so that the screws cannot fall into the guide for the panorama sunroof mechanism.

- Install the glass panel from the top into the roof.

- Gently pull the inner seal - 3 - inward at the marked locations - arrow - and install the screws - 2 -, but do not tighten them.






- Adjust the rear glass panel. Refer to => [ Front and Rear Glass Panel Height, Adjusting ] Front and Rear Glass Panel Height, Adjusting

- After the rear glass panel is adjusted, tighten the screws to 5 Nm.

- After completing all work, perform an adaptation of the sunroof motor => [ Panorama Sunroof Adaptation ] Panorama Sunroof Adaptation.