Headlamp Beam Adjustment Motor (V48)/(V49)

Headlamp Beam Adjustment Motor (V48)/(V49)

The Left headlamp beam adjustment motor (V48) and/or right headlamp beam adjustment motor (V49) is installed next to the low beam headlamp bulb in the headlamp.

• If the motors are removed and installed again or replaced, check the headlamp adjustment and adjust it again if necessary.

• The following figures show the removal and installation of the left headlamp control motor. The removal and installation of the right headlamp control motor are identical.

Removing

- Remove the headlamp. Refer to => [ Headlamps ] Headlamps.

- Turn the cap - 1 - all the way in - direction of arrow - and remove it.






- Turn the headlamp beam adjustment motor - 3 - in - direction of the arrow - to the stop.






- Tilt the ball head of the control motor - 2 - downward out of the mount in the headlamp - 1 - and remove the control motor - 3 - from the headlamp housing.

- Disconnect the connector - 1 - from the motor - 2 -.






Installing

Install in reverse order of removal. Note the following:

- Connect the connector to the motor and insert the headlamp beam adjustment motor into the headlamp in the installation position.

- Tilt the ball head of the headlamp beam adjustment motor - 2 - from underneath into the mount - 1 - while pulling the reflector backward.






- Insert the control motor - 3 - into its mount and lock it by turning in the - direction of the arrow - to the stop.

During installation, ensure proper seating of the cap. It is destroyed by ingress of water into headlamp.

- Check headlamp for functions.

- Check the headlamp adjustment and adjust if necessary.