Relay Panel On Vehicle Electrical System Control Module

Relay Panel On Vehicle Electrical System Control Module

The relay panel on the vehicle electrical system control module is attached directly to the vehicle electrical system control module.

The relay panel is clipped under the vehicle electrical system control module and can be removed separately.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the trim inside the driver footwell.

- Remove the fuse panel in the instrument panel. Refer to => [ Instrument Panel Fuse Panel ] Instrument Panel Fuse Panel.

- Press both catches - arrows - and move the Vehicle electrical system control module (J519) slightly downward.






- Pull the vehicle electrical system control module downward and opposite the direction of travel and remove it from the bracket.

- Turn the vehicle electrical system control module while paying attention to the connected wires.

- Unlock both catches - arrows - and remove the relay panel - 1 - from the vehicle electrical system control module - 2 - in - direction of arrow -.






- Press the 2 release buttons on the back of the relay connector - arrows - inward and remove the relay connector - 1 - together with the relay from the relay panel - 2 -.






- Perform this procedure consecutively at all available relays and then remove the relay panel - 2 -.

Installing

Installation is performed in the reverse order of removal. Note the following:

• Make sure the relay connectors are attached securely inside the relay panel and that the relay panel is attached securely to the vehicle electrical system control module.