Tire Pressure Sensor, (Service Version)

Tire Pressure Sensor, (Service Version)

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1410)

Perform the following:

Removing

- Remove the tire from the disk wheel.

See which version is installed before starting any work.






I - Service version

The tire pressure sensor is attached to the valve with an inner TORX screw - 1 - on the Service version.

If a Service version is installed, then perform the following procedure.

II - Production version

The tire pressure sensor is attached to the valve with a square screw with a flat head - 2 - on the production version.

If a production version is installed, then perform the following procedure => [ ] Tire Pressure Sensor, (Production Version).

- Remove the screw - arrow - from the tire pressure sensor - 1 -.






- Counterhold metal valve using retainer (for example 2 mm spiral bore) while doing so.

Installing

• Clean the valve opening before installing the tire pressure sensor.

- Press the tire pressure monitoring sensor - 1 - onto the disk wheel (rim) and tighten - arrow -.






- Counterhold metal valve using retainer (for example 2 mm spiral bore) while doing so.

• Visually check the valve after installing it and make sure it is tight. The tire pressure sensor - 1 - must not have any play when it is installed and it must touch the rim bed.

• Do not tighten the valve again to the tightening specification after it has been installed.

Tightening Specifications