Power Seat Motor
Testing and Inspection
Locations
Service and Repair- Procedures
- With Heated Seat
- Front Height Adjustment Motor (Front Motor)
- Front-Rear Adjustment Motor (Center Motor)
- Rear Height Adjustment Motor (Rear Motor)
- Backrest Motor and Potentiometer
- Potentiometer & Shaft For Front-Rear Adjustment Motor
- Potentiometer For Front Height Adjustment Motor
- Potentiometer For Rear Height Adjustment Motor
- Without Heated Seat
- With Heated Seat
- Removal and Replacement
- Procedures
Diagrams- Diagram Information and Instructions
- Diagnostic Aids
- Checking the Result of the Crimping Operation
- Checking the Voltage Drop Over Signal Ground
- Extracting the Cable Terminal From the Housing
- Cable Terminals, Different Types
- Primary Locking In General
- Using Terminal Removal Tools
- When the Cavity Opening Has Two Extraction Grooves
- Cavity Opening With One Extraction Groove
- Housing With Half-Open Contact Side
- Housings With Square Cavity Openings
- Housings With Round Cavity Opening
- Single Terminal Housings
- Glossary
- Ground Points and Oxidation
- Inserting A Cable Terminal In A Housing
- Open the Connector
- Replacing Cable Terminals
- Soldering, General
- Stripping a Cable
- Terminal Crimping
- Operating Procedures For Repairs
- Connectors, Repair
- Connector
- Connector Brake Control Module (BCM), Repair
- Connector Control Module for Anti-Lock Brake System Module (ABS), Repair
- Connector Data Link Connector (DLC), Repair
- Connector Door, Repair
- Connector Fuse Holder, Repair
- Connector Relay Box, Repair
- Connector Supplemental Restraint System Module (SRS), Repair
- Connector Type 1
- Connector Type 2
- Connector Type 3
- Connector Type 4
- Connector Type 6
- Connector Type 7
- Connectors
- Sealed Connector Type 1
- Sealed Connector Type 2
- Sealed Connector Type 3
- Wiring
- Electrical Diagrams