VSA System

VSA DTC Troubleshooting: 113

DTC 113:

Yaw Rate-Acceleration Sensor Power Source Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

1. Turn the ignition switch to LOCK (0).

2. Disconnect the yaw rate-lateral/longitudinal acceleration sensor 4P connector Service and Repair.

3. Turn the ignition switch to ON (II).

4. Measure the voltage between body ground and yaw rate-lateral/longitudinal acceleration sensor 4P connector terminal No. 1.





Is there battery voltage?

YES -

Replace the yaw rate-lateral/longitudinal acceleration sensor Service and Repair.�

NO -

Repair an open in the wire between the No. 29 (10 A) fuse in the under-dash fuse/relay box and the yaw rate-lateral/longitudinal acceleration sensor.�