Front Passenger's Power Seat Motor Test

Front Passenger's Power Seat Motor Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the front passenger's power seat Front Seat Removal/Installation.

2. Remove the power seat adjustment switch (B) Front Seat Disassembly/Reassembly and disconnect the 12P connector (A) from the switch.






3. At the power seat adjustment switch 12P connector, test the motor by applying battery power and ground to the terminals according to the table.

Slide motor:





Recline motor:





Front up-down motor:





Rear up-down motor:





4. If the motor does not run or fails to run smoothly, check for an open in the front passenger's seat wire harness between the power seat adjustment switch and each motor. If the wire harness is OK, replace the appropriate motor Front Seat Linkage Disassembly/Reassembly.

NOTE: The slide motor is not available separately because it is assembled into the left seat track; refer to seat linkage disassembly/reassembly Front Seat Linkage Disassembly/Reassembly.