U1280

DTC Troubleshooting: U1280, U1280, U1280, U1280, U1280, U1280, U1280, U1280, U1280, U1280, U1280

DTC U1280:

Communication bus Line Error (BUS-OFF)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC U1280 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections, or worn/shorted wires. If the connections are good, check the battery condition Testing and Inspection and the charging system.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Disconnect the appropriate connector at each control unit in the table one at a time. Clear the DTC, then recheck for DTCs after each unit is disconnected.









Is DTC U1280 indicated with each individual unit disconnected?

YES -

Leave the connectors disconnected, and go to step 7.

NO -

Do the input test (or circuit troubleshooting) for the control unit that was disconnected when DTC U1280 did not reset and perform all power and ground input tests. If the tests prove OK, replace that unit.�

- Passenger's MICU input test
- Door multiplex control unit (power window master switch) input test Power Window Master Switch Input Test
- Gauge control module input test Gauge Control Module Input Test
- Power control unit input test
- Keyless access control unit input test Keyless Access System (Keyless Access, Keyless Access Remote Slot, and Power Control Units) Input Test
- Remote slot control unit input test
- Immobilizer-keyless control unit input test Immobilizer-Keyless Control Unit Input Test (Without Keyless Access System)
- Climate control unit power and ground circuit troubleshooting Climate Control Power and Ground Circuit Troubleshooting
- Power seat control unit input test Power Seat Control Unit Input Test/Replacement
- HandsFreeLink control unit input test HandsFreeLink Control Unit Input Test
- AcuraLink control unit input test
- Audio unit input test
- Audio-navigation unit input test

7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

8. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal/Installation.

9. Disconnect driver's under-dash fuse/relay box connector P (20P).

10. Check for continuity between driver's under-dash fuse/relay box connector P (20P) terminals No. 5 and No. 6.





Is there continuity?

YES -

Repair a short in the B-CAN wires.�

NO -

Go to step 11.

11. Check for continuity between body ground and driver's under-dash fuse/relay box connector P (20P) terminals No. 5 and No. 6 individually.





Is there continuity?

YES -

Repair a short to ground in the wire(s).�

NO -

Go to step 12.

12. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

13. Measure the voltage between body ground and driver's under-dash fuse/relay box connector P (20P) terminals No. 5 and No. 6 individually.





Is there voltage?

YES -

Repair a short to power in the wire(s).�

NO -

Faulty driver's MICU, replace the driver's under-dash fuse/relay box Drivers Under-Dash Fuse/Relay Box (Drivers MICU) Removal and Installation.�