Low Oil Pressure Indicator Circuit Troubleshooting - Open

Low Oil Pressure Indicator Circuit Troubleshooting - Open

1. Connect the HDS to the DLC.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle and the PCM. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.

4. Check for DTCs Initial Inspection and Diagnostic Overview. If a DTC is present, diagnose, and repair the cause before continuing with this test.

5. Start the engine, and check the OIL PRESSURE SWITCH in the PGM-FI DATA LIST with the HDS.

Is ON indicated?

YES -

Replace the gauge control module Service and Repair.�

NO -

Go to step 6.

6. Turn the ignition switch to LOCK (0).

7. Check the oil pressure switch Testing and Inspection.

Is the oil pressure switch OK?

YES -

Go to step 8.

NO -

Do the oil pressure test Testing and Inspection. if the oil pressure is OK, replace the oil pressure switch Service and Repair.�

8. Turn the ignition switch to ON (II), and jump the SCS line with the HDS, then turn the ignition switch to LOCK (0).

NOTE: This step must be done to protect the PCM from damage.

9. Disconnect PCM connector C (49P) and the oil pressure switch connector.

10. Check for continuity between PCM connector terminal C45 and the oil pressure switch connector.





Is there continuity?

YES -

Update the PCM if it does not have the latest software PCM Update, or substitute a known-good PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM Service and Repair.�

NO -

Repair an open in the wire between the oil pressure switch and PCM connector terminal C45.�