Lighting and Horns: Service and Repair
Exterior Lights Bulb Replacement
Headlight Bulb (High Beam)
1. Remove the parts shown:
- Battery trim
- Upper grille cover Upper Grille Cover Replacement
- Right upper fender trim
2. For the left headlight, remove the battery hold-down by removing the two nuts, then slide the battery to access the bulb.
3. Disconnect the 2P connector (A) from the headlight bulb socket (B).
4. Turn the bulb socket 45 ° counterclockwise to remove it from the headlight housing.
5. Install a new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
NOTE: Do not touch the glass of the bulb with your hands. If necessary, clean the glass area with alcohol.
Front Parking Light/Front Side Marker Light Bulb
1. Remove the parts shown:
- Battery trim
- Upper grille cover Upper Grille Cover Replacement
- Right upper fender trim
2. For the left light, remove the battery hold-down by removing the two nuts, then slide the battery to access the bulb.
3. For the right parking light/front side marker light, remove the clip from the windshield washer reservoir.
4. Disconnect the 2P connector (A) from the front parking light/front side marker light bulb socket (B).
5. Turn the bulb socket 45 ° counterclockwise to remove it from the headlight housing.
6. Install a new bulb in the reverse order of removal.
Front Turn Signal Light Bulb
1. Remove the parts shown:
- Battery trim
- Upper grille cover Upper Grille Cover Replacement
- Right upper fender trim
2. For the left light, remove the battery hold-down by removing the two nuts, then slide the battery to access the bulb.
3. Disconnect the 3P connector (A) from the bulb socket (B).
4. Turn the bulb socket 45 ° counterclockwise to remove it from the headlight housing.
5. Install a new bulb in the reverse order of removal.
Fog Light Bulb
1. Remove the bolts and clip, then push up the splash shield.
2. Disconnect the 2P connector (A) from the fog light (B).
3. Turn the bulb socket (C) 45 ° counterclockwise to remove it from the housing.
4. Install a new bulb in the reverse order of removal.