Operation CHARM: Car repair manuals for everyone.

Safing Sensor: Service and Repair




Rear Safing Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the rear seat Rear Seat Removal / Installation.

3. Disconnect the left side wire harness 2P connector (A) from the rear safing sensor.





4. Remove the TORX bolts (B) using a TORX T30 bit, then remove the rear safing sensor (C).

Installation

1. Install the rear safing sensor with a new TORX bolts (A), then connect the left side wire harness 2P connector (B) to the rear safing sensor (C).





2. Do the battery terminal reconnection procedure.

3. Clear any DTCs with the HDS.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator should come on for about 6 seconds and then go off.

5. Reinstall all removed parts.