Diagnostic Modes Description

Diagnostic Modes Description

The information provided in Modes 01 through 09 displays the various levels of emission related data that may be monitored, as well as the ability to retrieve and read stored DTC trouble codes , erase stored DTC trouble codes, generate readiness codes, and select the various PIDs and Test-IDs used within the modes to monitor the engine, and emission related component parameters.

The following table provides a link to all diagnostic modes that monitor all components and systems which influence the emission quality.

NOTE: Depending on scan tool and protocol used, the information displayed may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and be referenced by only a number.

Selectable diagnostic modes

Mode 1:Obtain data. Diagnostic Mode 01: Obtain Data

Mode 2:Obtain operating conditions. Diagnostic Mode 02: Obtain Operating Conditions

Mode 3:Interrogating fault memory. Mode 03: Interrogating Fault Memory

Mode 4:Reset/delete diagnostic data. Diagnostic Mode 04: Reset/Delete Diagnostic Data

Mode 5:Obtain lambda test results. Diagnostic Mode 05: Check Lambda Test Results

Mode 6:Checking test results of components that are not continuously monitored. Diagnostic Mode 6: Checking Test Results of Components That Are Not Continuously Monitored

Mode 7:Checking test results of components that are continuously monitored. Diagnostic Mode 07: Check Test Results of Components That Are Continuously Monitored

Mode 8:Tank leak test. Diagnostic Mode 08: Tank Leak Test

Mode 9:Vehicle information. Diagnostic Mode 09: Vehicle Information