Engine Lubrication: Service and Repair

Upper Oil Pan, Oil Filter, Chain Tensioner Component Overview

• Oil injector jet for piston cooling => [ Oil spray jet for piston cooling ]





1 Torque bracket

2 40 Nm

3 Torque support stop

• Adjusting: Allow torque support stop to come in contact under its own weight with torque support rubber buffer and tighten screws.

4 28 Nm

5 Seal

• Replace

6 Oil Pressure Switch (F1)

• Black insulation

• Checking, refer to => [ Oil Pressure and Oil Pressure Switch, Checking ] Testing and Inspection

• Replace seal

• Tighten to 25 Nm

7 12 Nm

8 Washer

9 O-ring

• Replace

10 Seal

• Replace

11 Locking bolt -10 Nm

12 Seal

• For crankshaft

• Replace, refer to => [ Crankshaft Seal, Ribbed Belt Side, Replacing ] Service and Repair

13 10 Nm

14 30 Nm

• Self-locking

• Replace

15 Sealing flange, front

• Removing and installing, refer to => [ Front Sealing Flange ] Service and Repair

16 Chain tensioner

• Removing and installing, refer to => [ Oil Pump Drive Chain or Chain Tensioner ] Oil Pump Drive Chain or Chain Tensioner

• Hold using 3 mm dia. drill bit

17 Gasket

• Replace

18 20 Nm

19 Guide tube for oil dipstick

20 Metal screw

21 O-ring

• Replace

22 Oil filter element

• Change intervals,

• Loosen using Oil Filter Wrench (3417)

• Observe installation instructions for oil filter

• Tighten to 20 Nm

23 30 Nm

24 Oil cooler

• See note, refer to => [ Lubrication System Components, Removing and Installing ] Description and Operation

25 Guide piece

• With gasket

• Replace

26 10 Nm

• Self-locking

• Replace

27 Upper oil baffle

28 45 Nm

29 M7 - 16 Nm; M8 - 22 Nm

30 Oil pan (upper section)

• Removing and installing, refer to => [ Upper Oil Pan ] Upper Oil Pan

Oil spray jet for piston cooling





1. Bolt -10 Nm

2. Oil spray jet for piston cooling