Clutch Release Mechanism, Clutch Slave Cylinder Assembly Overview

Clutch Release Mechanism, Clutch Slave Cylinder Assembly Overview






1 Bolt

• Replace

• 12 Nm for metal clutch slave cylinder

• 15 Nm for plastic clutch slave cylinder

• Quantity: 3

• Carefully tighten diagonally in small stages so that the clutch slave cylinder bolting tabs do not break off

2 Clutch Slave Cylinder with Release Bearing

• The clutch slave cylinder and release bearing are one unit and can only be replaced together.

• Do not wash the bearing, just wipe it off.

• If the bearing is noisy, replace it together with the clutch slave cylinder

• Removing and installing, refer to => [ Slave Cylinder with Release Bearing ] Service and Repair

3 O-ring

• Replace if damaged

• Pull onto line connection

• Install with brake fluid

4 Retaining Clip

5 Vent Screw

• Tightening specification - 17 - => [ Vent Screw ] Hydraulics Assembly Overview

6 Protective Cap

7 Retaining Clip

8 Hose/line Assembly or Plastic Line

• To the clutch slave cylinder

• Removing and installing, refer to => [ Hose/Line Assembly or Plastic Line ] Service and Repair

9 O-ring

• Replace if damaged

• Pull onto line connection

• Install with brake fluid

10 Bleeder

• Removing and installing, refer to => [ Slave Cylinder with Release Bearing ] Service and Repair

11 Shaft Seal

• For input shaft

• Removing and installing, refer to => [ Input Shaft Seal ] Input Shaft Seal