Vehicle Electrical System Control Module

Vehicle Electrical System Control Module

Removing

- If the control module was replaced, select the Replace function for the respective control module in Guided Fault Finding or Guided Functions.

- Select the function or path.






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Switch off ignition and remove ignition key.

- Remove the driver side instrument panel cover.

- Disengage the 3-pin relay/fuse panel by pressing the retaining springs in the - direction of the arrow - and remove the relay/fuse panel - 1 -.





- Remove the electrical wire - 1 - on the 4-pin relay/fuse panel.





- Release the retaining spring - arrow A - and tilt the relay/fuse panel - 3 - out of the mount - arrow B -.

• Disregard item - 2 -.

- Release the retaining spring - arrow - and remove the vehicle electrical system control module (J519) - item 1 - downward from the mount.





- Disconnect the electrical connectors - 2, 5, 6, 7 and 8 -.

- Disconnect the electrical connectors - 3 - and - 4 -.

- To disconnect the electrical connector, press the catch - 1 -, rotate the retaining bracket in the - direction of the arrow - and remove the connector.





Installing

Install in reverse order of removal, observing the following:

• Tightening specification => [ 4-pin relay/fuse panel with
threaded connection, tightening specifications ] Relay Carrier and Fuse Panel In Instrument Panel and A-Pillar Assembly Overview.

- Install the driver side instrument panel cover.