Pass-Through Cover Lock Cylinder

Pass-Through Cover Lock Cylinder

Removing






- Flip the center armrest up.

Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

- Insert the key - 3 - into the lock cylinder - 2 - correctly.

- Turn the key counterclockwise 90° - 3 -.

- Push the pass-through handle - 1 - up as far as the stop.

- Release the tabs - arrows - and press the lock cylinder - 2 - with the key - 3 - out of the handle.

Installation

Install in reverse order of removal. Note the following:

• Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

• Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.

- Slide the lock - 3 - into the new lock cylinder - 2 - correctly.






- Remove the cap - 4 - from the new lock cylinder.

- Insert the lock cylinder into the pass-through door handle - 1 -. Pay attention to the installed position.

- Turn the key 90° clockwise.

• Installation position of the lock cylinder: the key slot must be vertical and the retaining tab - arrow - must point to the right, opposite the direction of travel.

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Rear Center Armrest Assembly Overview ] Rear Center Armrest Assembly Overview.