Intake Manifold, Upper Section Assembly Overview

Intake Manifold, Upper Section Assembly Overview






1 Vacuum hose

2 Intake Manifold Tuning (IMT) Valve (N156)

3 Bolt

• For Intake Manifold Tuning (IMT) Valve Position Sensor (G513)

• 2.5 Nm

4 Bolt

• 2.5 Nm

5 Actuator for intake manifold change-over

• Installed location of tooth segments for variable intake manifold => [ Installed location of tooth segments for variable
intake manifold ]

• As replacement part together with - 26 -

6 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

7 Ball pin

• 2.5 Nm

8 Intake manifold upper section

• Removing and installing, refer to => [ Intake Manifold, Upper Section ] Intake Manifold, Upper Section

9 Seal

• Replace

10 Throttle valve control module (J338)

11 Bracket

12 Bolt

• 6 Nm

13 Evaporative Emission (EVAP) Canister Purge Regulator Valve (N80)

14 Hose

15 Bolt

• 3 Nm

16 Intake Air Temperature (IAT) Sensor (G42)/Manifold Absolute Pressure (MAP) Sensor (G71)

17 O-ring

• Replace

18 Bolt

• 2.5 Nm

19 Hose for crankcase ventilation

20 O-ring

• Replace

21 Bolt

• 8 Nm

22 Washer

23 Sleeve

24 Seals

• Replace

25 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

26 Lever with tooth segment

• For variable intake manifold

• Installed location of tooth segments => [ Installed location of tooth segments for variable
intake manifold ]

• As replacement part together with - 5 -

27 Seal

• Replace if damaged

• Lift out with screwdriver to replace

• Press in by hand

28 Vacuum hose

Installed location of tooth segments for variable intake manifold





• The lower edges of the toothed segments must align with one another - arrow -.