Electronic Brake Control Module Replacement

Electronic Brake Control Module Replacement

Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (Brake Fluid Irritant Warning).


Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (Brake Fluid Effects on Paint and Electrical Components Caution).

1. Remove the electronic brake and traction control module with brake pressure modulator valve assembly. Refer to Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement (Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement).




2. Remove the electronic brake control module (EBCM) bolts (1),




3. Carefully separate the EBCM (1) from the brake pressure modulator valve (BPMV).

Note: Do not pry the components apart.

4. Clean the sealing surfaces of the EBCM and the brake pressure modulator valve with denatured alcohol and allow to dry.

Installation Procedure




1. Install the EBCM (1) to the BPMV.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the EBCM bolts (1) and tighten to 3 Nm (26 lb in) ,
3. Install the electronic brake and traction control module with brake pressure modulator valve assembly. Refer to Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement (Electronic Brake and Traction Control Module with Brake Pressure Modulator Valve Replacement).
4. Program the EBCM. Refer to Control Module References (Programming and Relearning).