Trim Panel Replacement - Right Body Side

Trim Panel Replacement - Right Body Side

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover


Removal Procedure

1. Remove the C and the D pillar trim. Refer to Trim Replacement - Third Pillar Right (Trim Replacement - Third Pillar Right) and Trim Replacement - Fourth Pillar Left (Trim Replacement - Fourth Pillar Left) .
2. Remove the jack access panel.
3. Remove the upper and the lower belt anchors. Refer to Seat Belt Retractor Replacement - No. 2 Left Rear or Seat Belt Retractor Replacement - No. 2 Right Rear in Seat Belts.
4. Remove the cargo net bolt.
5. Remove the screw that retains the panel to the C pillar.




6. Use the J 38778 in order to release the fasteners that retain the panel to the vehicle.



Installation Procedure





1. Install the panel to the vehicle:

1. Align the retaining clips with the holes in the body.
2. Press the panel down in order to seat the fasteners into place.


Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the screw that retains the panel to the C pillar.

Tighten the screw that retains the panel to the C pillar to 2 N.m (18 lb in).

3. Install the cargo net bolt.

Tighten the cargo net bolt to 2 N.m (18 lb in).

4. Install the jack access panel.
5. Install the upper and the lower mounting bolts for the rear seat belt. Refer to Seat Belt Retractor Replacement - No. 2 Left Rear Seat Belt Retractor Replacement - No. 2 Right Rear in seat belts.
6. Install the C and the D pillar trim. Refer to the appropriate procedure:

* Trim Replacement - Third Pillar Right (Trim Replacement - Third Pillar Right)
* Trim Replacement - Fourth Pillar Left (Trim Replacement - Fourth Pillar Left)