B223D

Diagnose and repair the DTCs.




B223D-OCCUPANT CLASSIFICATION MODULE DTC PRESENT

- When Monitored:
With the ignition on.

- Set Condition:
This DTC will set if the ORC receives a bus message with the active OCM DTC Present bit set.





1. VERIFY THAT DTC B223D-OCCUPANT CLASSIFICATION MODULE DTC IS ACTIVE
1. With the scan tool, read the OCCUPANT RESTRAINT CONTROLLER active DTCs.

Does the scan tool display active: B223D-OCCUPANT CLASSIFICATION MODULE?

Yes

- Go To 2

No

- With the scan tool, perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.

2. ACTIVE DTC IN OCCUPANT CLASSIFICATION MODULE
1. With the scan tool, read the OCCUPANT CLASSIFICATION MODULE active DTCs.

Are there any active DTC present?

Yes

- Diagnose and repair the DTCs. Testing and Inspection.

No

- Go To 3

3. REPLACE THE OCCUPANT RESTRAINT CONTROLLER

WARNING: Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

If there are no possible causes remaining, view repair.

Repair

- Replace the Occupant Restraint Controller.
- Perform the ORC VERIFICATION TEST. Occupant Restraint Controller (ORC) Verification Test.