Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle




1. Thread the turn signal switch assembly connector through the steering column housing assembly, if the connector is hanging.





Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the turn signal switch assembly and secure using 3 binding head cross recess screws (1).

Tighten the 3 binding head cross recess screws to 3.5 Nm (31 lb in).

3. Lubricate the signal switch arm actuator (3) with lithium grease.
4. Install the signal switch arm actuator (3) onto the turn signal switch assembly.
5. Secure the signal switch arm actuator (3) using the round washer head screw (2).

Tighten the round washer head screw (2) to 2.5 Nm (22 lb in).




6. Install the terminal connector to the turn signal switch assembly connector.
7. Install the terminal connector to the dimmer switch assembly.




8. Pull the turn signal switch assembly connector towards the base of the column.
9. Insert the wire protector into the steering column bracket.
10. Insert the steering column wire harness into the steering column wire harness strap.
11. Install the turn signal cancel cam components. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle.
12. Install the hazard knob. Refer to Hazard Warning Switch Replacement Tilt.
13. Install the multifunction lever. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle Multifunction Turn Signal Lever Replacement - On Vehicle.
Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle Tilt Lever Replacement - On Vehicle.