Consult-III Function (All Mode AWD/4WD)

CONSULT-III Function (ALL MODE AWD/4WD)

FUNCTION
CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.





SELF-DIAG RESULT MODE
Drive at 30 km/h or more for approximately 1 minute before performing the self-diagnosis.

Display Item List:

How to Erase Self-Diagnostic Results
Before erasing DTC memory, start the engine and drive at 30 km/h or more for approximately 1 minute. Check that ABS warning lamp turns OFF.

NOTE: Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch "OFF" if AWD, warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD, warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.

DATA MONITOR MODE

Display Item List:

ACTIVE TEST MODE

Description
Use this mode to determine and identify the details of a malfunction based on self-diagnostic results or data monitor. AWD control unit gives drive signal to actuator with receiving command from CONSULT-III to check operation of actuator.

Test Item: