Removal and Installation

CENTER CONSOLE ASSEMBLY


Removal and Installation


CAUTION:
When removing, always use a remover tool that is made of plastic.

REMOVAL
1. Put selector lever in drive position.
2. Remove selector lever knob.
- Removal and Installation.(2WD models)
- Removal and Installation.(AWD models)





3. Remove console finisher assembly.
- Pull console finisher (1), upward to disengage from center console.
- Disconnect harness connectors.

Triangle: Pawl
Square : Metal clip





4. Disconnect console sub harness connectors (A).
5. Remove center console fixing screws (B).
6. Put front seat to front must position.





7. Remove console rear finisher.
- Pull back the console rear finisher (1) with remover tool (A).
- Disconnect inside key antenna connector.

Square : Metal clip





8. Remove rear ventilator duct (1). .
9. Remove center console fixing screws (A).
10. Remove center console assembly.
- Lift up center console assembly back side.
- Disconnect harness connectors.

INSTALLATION
Install in the reverse order of removal.