Operation CHARM: Car repair manuals for everyone.

Removal and Installation





BACK DOOR


BACK DOOR ASSEMBLY : Removal and Installation


CAUTION:
- Operate with two workers, because of its heavy weight.
- Use protective tape or shop cloth to protect from damage during removal and installation.

NOTE:
The back door harness constitute the back door assembly.

REMOVAL
1. Remove back door finisher inner, back door plate and back door hinge cover. Removal and Installation.
2. Remove clips of headlining at rear end. Removal and Installation.
3. Disconnect connectors and bolts of back door harness.
4. Remove back door grommet (LH), and then pull harness out of vehicle at roof panel hole.
5. Remove back door plate, and then disconnect washer tube. Exploded View and Rear Washer Nozzle and Tube.
6. Pull washer tube out of back door.
7. Support back door lock with the proper material to prevent it from falling.

WARNING:
Bodily injury may occur if no supporting rod is holding the back door open when removing the back door stay.
8. Remove back door stay. Removal and Installation.
9. Remove back door hinge mounting bolts on back door and remove back door assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check back door hinge rotating part for poor lubrication. If necessary, apply body grease.
- After installation, check back door open/close, lock/unlock operation.
- After installation, perform the fitting adjustment. Adjustments.
- After installation, perform the camera image calibration. Navigation (Single Monitor) Navigation (Single Monitor) Navigation (Single Monitor) Navigation (Single Monitor), "CALIBRATING CAMERA
Navigation (Twin Monitor) Navigation (Twin Monitor) Navigation (Twin Monitor) Navigation (Twin Monitor), "CALIBRATING
CAMERA IMAGE (AROUND VIEW MONITOR) : Work Procedure" (twin monitor).