P181F

P181F INCOMPLETE CALIBRATION





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.DTC REPRODUCTION PROCEDURE
With CONSULT-III
1. Turn the ignition switch OFF to ON.
2. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "P181F" detected?
YES - Proceed to diagnosis procedure. SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.PERFORM INITIAL CALIBRATION
1. Erase self-diagnostic result for "ALL MODE AWD/4WD".
2. Perform initial calibration. Work Procedure.
3. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is any DTC except "P181F" detected?
YES - Check DTC.
NO - GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Erase self-diagnostic result for "ALL MODE AWD/4WD".
2. Turn the ignition switch OFF, and then wait 10 seconds or more.
3. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "P181F" detected?
YES - Replace transfer control unit. Service and Repair.
NO - Check transfer control unit pin terminals for damage or loose connection with harness connector.
If any items are damaged, repair or replace the error-detected parts.