Disassembly and Assembly

THIRD ROW SEATS

Exploded View













THIRD ROW SEATS

Disassembly and Assembly


SEATBACK

Disassembly
1.Remove third row seat. Refer to "Removal and Installation" Removal and Installation.
2.Release the pawls and remove the top tether anchor finisher from seatback board.
3.Remove the screw and the luggage hook.
4.Press both headrest holder lock buttons in and lift headrest up to remove.
5.Remove the seatback board.





a.Release the hook fastener (A) along the upper edge.
b.Release the upper clips (B) that retain the seatback board to the seatback frame.
c.Release the remaining clips in the order shown.
6.Remove the seatback trim and pad as an assembly.
Revision: March 20122013 Infiniti JX





a.Slide the clip tabs (A) out of the raised slots (B) on the top edge of the seatback frame sheet metal as shown.
b.Repeat at the lower and RH/LH edges.





c.Squeeze the headrest holder tabs at the base of the stay pipe and pull up to remove as shown.

CAUTION:
Before removing headrest holder, check its orientation (front/rear and right/left).
d.Push the lower cross strap beneath seatback frame, then lift the seatback trim and pad assembly up and remove.
7.Remove the screw and the pull strap from seatback frame.
Revision: March 20122013 Infiniti JX
8.Remove the seatback release handle and cable.
a.Remove the screw (A) and release the cable clip (B) from the seatback frame b.Rotate the cable end collar (C) and the hook (D) to release from the cable brackets.
c.Remove the seatback release cable and lever as an assembly from the seatback frame.





9.Remove the hog rings and separate the seatback trim and seatback pad.
NOTE:
Remove all pieces of hog rings and discard them.
Assembly
Assembly is in the reverse order of disassembly.

CAUTION:
- Make sure hog rings are correctly fastened around both the seat trim and pad wires.
- Replace any deformed or damaged hog rings.
- Make sure any old hog ring pieces are removed from seat.
NOTE:





- Install new hog rings on the seatback trim in their original positions.
: Hog ring
Right side shown, left side similar.
- Use only one hog ring in each designated location.
- Be sure hook fastener (A) is pressed into place after seatback trim is assembled.

SEAT CUSHION

Disassembly
Revision: March 20122013 Infiniti JX
1.Remove third row seat. Refer to "Removal and Installation" Removal and Installation.
2.Remove seat cushion trim and seat cushion pad.





a.Release the J-clips holding the seat cushion to the seat frame.
b.Release the elastic band and route the seat belt buckles (LH/RH).
c.Lift the seat cushion trim and seat cushion pad from the seat frame as an assembly.
3.Release the hook fasteners, then remove the hog rings to separate the seat cushion trim and seat cushion pad.
4.Remove the screw, release the metal clip and pawls, then remove the seat hinge finishers (LH/RH) from the seat frame.
5.Release the pawls and remove the seat hinge finisher (center) from the seat frame.
Assembly
Assembly is in the reverse order of disassembly.

CAUTION:
- Make sure hog rings are correctly fastened around both the seat trim and pad wires.
- Replace any deformed or damaged hog rings.
- Make sure any old hog ring pieces are removed from seat.
NOTE:





- Install new hog rings on the seat cushion trim in their original positions.
: Front
: Hog ring
- Use only one hog ring in each designated location.
- Be sure hook fastener (A) is pressed into place after seatback trim is assembled.
Revision: March 20122013 Infiniti JX