Description

MILLIMETER WAVE SENSOR ALIGNMENT

Description


WARNING:
Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before use.

OUTLINE OF RADAR ALIGNMENT PROCEDURE

- A 4-wheel vehicle alignment must be performed before proceeding with radar alignment procedure.
- Always perform the radar alignment after removing and installing or replacing the millimeter wave sensor.

CAUTION:
The system does not operate normally unless the millimeter wave sensor is aligned properly.
1.Preparation, refer to "Preparation" Preparation.
2.Vehicle set up, refer to "Vehicle Set Up" Vehicle Set Up.
3.Setting the ICC target board, refer to "Setting The ICC Target Board" Setting the ICC Target Board.
4.Millimeter wave sensor adjustment, refer to "Millimeter Wave Sensor Adjustment" Millimeter Wave Sensor Adjustment.

CAUTIONARY POINT FOR RADAR ALIGNMENT PROCEDURE


CAUTION:
- For radar alignment procedure, choose a level location with a few feet of working space in front and surrounding the vehicle.
- Vehicle must be stationary and unoccupied during the whole alignment procedure.
- Any slight vibration during the alignment procedure can cause the test to fail. If this happens, you will have to restart the alignment process.
- The ignition switch must be in the ON position.
- The battery voltage must not fall below 12 volt during the whole alignment procedure. Failure to maintain adequate battery voltage will cause the test to fail. If this happens, you will have to restart the alignment process.
- The ICC target board must be set in front of the vehicle facing the sensor.
- Adjust the radar alignment with CONSULT. (The radar alignment procedure cannot be adjusted without CONSULT.)
- Never enter the vehicle during radar alignment.
- Never block the area between the radar and the ICC target board at any time during the alignment process.
- Never break the laser beam between the laser assembly and front ICC target board or rear reflector at any time during alignment.
- Accurate steering wheel setting is crucial. Once set, do not disturb the steering wheel for the remainder of the alignment procedure.
- To avoid physical damage, the millimeter wave sensor adjustment screw must not be forced to either clockwise or counter-clockwise limit. For proper adjustment procedure, follow the directions of the
CONSULT exactly as instructed.
- For proper system operation and adjustment, all vehicle wheels must be of the same size.