B260F

B260F ENGINE STATUS

Description

BCM receives the engine status signal from ECM via CAN communication.


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"DTC Logic" Body Control System.
- If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"DTC Logic" Body Control System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON and wait 2 seconds or more.
2.Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT.
Is DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. INSPECTION START

1.Turn ignition switch ON.
2.Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
3.Touch "ERASE".
4.Perform DTC CONFIRMATION PROCEDURE for DTC B260F. Refer to "DTC Logic" .
Is DTC detected?
YES- GO TO 2.
NO- INSPECTION END

2. REPLACE ECM

1.Replace ECM. Refer to "Removal and Installation" For USA and Canada.
2.Perform "ADDITIONAL SERVICE WHEN REPLACING ECM". Refer to "Work Procedure" For USA and Canada.
- INSPECTION END