Configuration (AV Control Unit)

INSPECTION AND ADJUSTMENT

CONFIGURATION (AV CONTROL UNIT) : Special Repair Requirement


1. SAVING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES- GO TO 2.
NO- GO TO 4.

2. REPLACE AV CONTROL UNIT

Replace AV control unit. Refer to "Removal and Installation" Service and Repair.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT Configuration
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to AV
control unit.
NOTE:
If selection items are not displayed on the CONSULT screen, touch "NEXT".
- GO TO 6.

4. REPLACE AV CONTROL UNIT

Replace AV control unit. Refer to "Removal and Installation" Service and Repair.
- GO TO 5.

5. WRITE VEHICLE SPECIFICATION

CONSULT Configuration
Select "Manual Configuration", and write the setting value as shown in the following table to AV control unit according to the vehicle specification.

CAUTION:
Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
NOTE:
- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.





NOTE:
AVM: Around view monitor
*: In the following table, find an illustration that the part matches the vehicle and select microphone type.





- GO TO 6.

6. PERFORM SELF-DIAGNOSIS

CONSULT Self Diagnostic Result
Perform self-diagnosis of CONSULT, and check whether or not DTC U122A is detected.
Is DTC U122A detected?
- GO TO 5.
- GO TO 7.

7. OPERATION CHECK

Check that the operation of the AV control unit and camera images (fixed guide lines and predictive course lines) are normal.
- WORK END