Removal and Installation

YAW RATE/SIDE/DECEL G SENSOR

Removal and Installation


REMOVAL


CAUTION:
Never drop or strike yaw rate/side/decel G sensor, because it has little endurance to impact. Never use a pneumatic tool.
1.Remove console finisher assembly. Refer to "Removal and Installation" Removal and Installation.
2.Disconnect yaw rate/side/decel G sensor harness connector.
3.Remove yaw rate/side/decel G sensor.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Never drop or strike yaw rate/transverse/decel G sensor, because it has little endurance to impact. Never use a power tool.
- Perform decel G sensor calibration when yaw rate/side/decel G sensor is removing/installing or replaced.
Refer to "Work Procedure" Work Procedure.