Rear Seat Cushion Cover

Rear Seat Cushion Cover

Removal
1 Remove the LH rear seat. For additional information, refer to Rear Seat Rear Seat




2 Remove the rear seat backrest outer hinge cover.
- Remove the 2 screws.




3 Remove the rear seat backrest inner hinge cover.
- Remove the 3 screws.




4 Remove the rear seat base lower trim panel.
- Remove the 6 clips.
- Reposition the rear seat hinge plates for access.




5 Remove the rear seat backrest inner hinge.
- Remove the 4 bolts.
- Discard the 2 lower bolts.




6 Remove the rear seat backrest from the rear seat base.
- Remove the rear seat backrest outer hinge bolt.
7 Remove the rear seat backrest hinge wiring harness clip.
- Remove the 2 clips.
- Release the rear seat base wiring harness electrical connector from the rear seat backrest cover.
- Disconnect the rear seat base wiring harness electrical connector.




8 Release the rear seat cushion cover from the rear seat base.
9 Reposition the rear seat base wiring harness through the rear seat base.
- Release the rear seat base wiring harness electrical connector from the clip.
- Release the 5 wiring harness clips.





10 Reposition the safety belt through the rear seat cushion cover and the rear seat cushion.
- Remove and discard the safety belt bolt from the rear seat base.





11 Remove the rear seat cushion cover and the rear seat cushion.





12 Remove the rear seat cushion cover from the rear seat cushion.
- Remove and discard the 25 rear seat cushion cover clips.

Installation
1 Install the rear seat cushion cover to the rear seat cushion.
- Install the 25 new rear seat cushion cover clips.
2 Install the rear seat cushion cover and the rear seat cushion.
3 Reposition the safety belt through the rear seat cushion cover and the rear seat cushion.
- Install the new safety belt bolt to the rear seat base and tighten to 31 Nm (23 lb.ft).
4 Reposition the rear seat base wiring harness through the rear seat base.
- Secure the 5 wiring harness clips.
- Install the rear seat base wiring harness electrical connector to the clip.
5 Secure the rear seat cushion cover to the rear seat base.
6 Install the rear seat backrest hinge wiring harness clip.
- Install the 2 clips.
- Connect the rear seat base wiring harness electrical connector.
- Secure the rear seat base wiring harness electrical connector to the rear seat backrest cover.
7 Install the rear seat backrest to the rear seat base.
- Install the rear seat backrest outer hinge bolt and tighten to 45 Nm (33 lb.ft).
8 Install the rear seat backrest inner hinge.
- Install the 4 bolts.
- Install the 2 new lower bolts.
- Tighten the bolts to 45 Nm (33 lb.ft).
9 Install the rear seat base lower trim panel.
- Reposition the rear seat hinge plates for access.
- Install the 6 clips.

10 Install the rear seat backrest inner hinge cover.
- Install the 3 screws.

11 Install the rear seat backrest outer hinge cover.
- Install the 2 screws.

12 Install the LH rear seat. For additional information, refer to Rear Seat Rear Seat