Rear Door: Adjustments

ENGINE HOOD / DOOR: REAR DOOR: ADJUSTMENT

ADJUSTMENT

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Service Precautions
2. INSPECT REAR DOOR
(a) Check that the clearance is within the standard range.





Standard range:





3. ADJUST REAR DOOR






(a) Loosen the bolts on the pillar side to adjust the door front and back, up and down.
Torque: 26 Nm (265 kgf-cm, 19 ft-lbf)






(b) Loosen the bolts on the door side to adjust the door up and down, and the door front side to side.
Torque: 27 Nm (275 kgf-cm, 20 ft-lbf)
HINT: Perform this procedure after replacing the centering bolt with the supplied bolt.





(c) When adjusting the door rear side to side and the rear door lock striker plate assembly, using a "torx" socket wrench (T40), loosen the screws until the striker can move. Lightly tap it with a brass bar for adjustment.
Torque: 23 Nm (235 kgf-cm, 17 ft-lbf)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION Repair Instruction - Initialization