Installation

THEFT DETERRENT / KEYLESS ENTRY: CERTIFICATION ECU: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

(a) Attach the 2 claws to install the certification ECU (smart key ECU assembly).

2. INSTALL ECU INTEGRATION BOX RH

(a) Install the ECU integration box RH with the 2 nuts and bolt.

(b) Attach the clamp.

(c) Connect all the connectors.

NOTICE:
* Do not twist the connectors of the ECUs when connecting them.
* Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY Installation

4. INSTALL DCM (TELEMATICS TRANSCEIVER) Installation

5. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation

6. INSTALL INSTRUMENT PANEL BOX DOOR COVER Installation

7. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

8. INSTALL LOWER INSTRUMENT COVER LH Installation

9. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

11. INSTALL INSTRUMENT SIDE PANEL RH Installation

12. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

13. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation

14. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

15. INSTALL COWL SIDE TRIM BOARD RH Installation

16. INSTALL DOOR SCUFF PLATE ASSEMBLY RH Installation

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

18. CHECK SRS WARNING LIGHT

(a) Check SRS warning light Diagnosis System.