Installation

CRUISE CONTROL: DRIVING SUPPORT ECU: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

(a) Attach the claw to install the driving support ECU assembly.

NOTICE:
When a new ECU is installed, perform initialization Testing and Inspection.

2. INSTALL ECU INTEGRATION BOX RH Installation

3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY Installation

4. INSTALL DCM (TELEMATICS TRANSCEIVER) Installation

5. INSTALL INSTRUMENT PANEL BOX ASSEMBLY Installation

6. INSTALL INSTRUMENT PANEL BOX DOOR COVER Installation

7. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Installation

8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

9. INSTALL INSTRUMENT SIDE PANEL RH Installation

10. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

11. INSTALL LOWER INSTRUMENT COVER LH Installation

12. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

13. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

14. INSTALL COWL SIDE TRIM BOARD RH Installation

15. INSTALL DOOR SCUFF PLATE ASSEMBLY RH Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

17. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.