Installation

PRE-COLLISION: DRIVER MONITOR ECU: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL DRIVER MONITOR ECU ASSEMBLY

(a) Install the driver monitor ECU assembly with the bolt.

(b) Connect the connector.

2. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY Installation

5. INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION Installation

6. INSTALL NO. 2 SWITCH HOLE BASE Installation

7. INSTALL INSTRUMENT SIDE PANEL LH Installation

8. INSTALL COWL SIDE TRIM BOARD LH Installation

9. INSTALL DOOR SCUFF PLATE ASSEMBLY LH Installation

10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

11. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.