Front Passenger Side Power Window Auto Up / Down Function Does Not Operate With Front Passenger Side Power Window Switch
WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
- Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch
DESCRIPTION
* If the auto up/down function does not operate, the cause may be one or more of the following:
* The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.
* The power window regulator switch has a malfunction.
* The Hall IC in the power window regulator motor has a malfunction.
* There is an open or short in the wiring between the power window regulator switch and power window regulator motor.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK FOR DTC
(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.
(b) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.
Result
B -- GO TO DTC B2311 B2311
C -- GO TO DTC B2312 B2312
D -- GO TO DTC B2313 B2313
A -- Continue to next step.
2. CHECK MANUAL UP/DOWN FUNCTION (POWER WINDOW REGULATOR SWITCH RH)
(a) Check that the manual up/down function using the front power window regulator switch can operate the front power window Operation Check.
OK:
Front passenger side door power window moves.
NG -- GO TO "Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch" Front Passenger Side Power Window Does Not Operate With Front Passenger Side Power Window Switch
OK -- Continue to next step.
3. READ VALUE USING TECHSTREAM (POWER WINDOW REGULATOR SWITCH RH)
(a) Use the Data List to check if the front power window regulator is functioning properly Scan Tool Testing and Procedures.
P-Door Motor
OK:
On tester screen, item changes between ON and OFF according to above chart.
NG -- INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal
4. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH
(a) Remove the power window regulator switch Removal.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY RH Removal
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH RH - FRONT POWER WINDOW REGULATOR MOTOR RH AND BODY GROUND)
(a) Disconnect the J1 power window regulator switch connector.
(b) Disconnect the J6 power window regulator motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal