B2313

WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: B2313: Glass Position Initialization Incomplete
B2313 - Glass Position Initialization Incomplete

DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor assembly has a motor, regulator and ECU.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT
This DTC may be stored for all the windows.

NOTICE:
* When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
* After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
(1) Close the power window by fully pulling up the power window switch and holding it in the auto up position.
(2) Open the power window by fully pushing down the power window switch.

D-Door Motor





P-Door Motor





RL-Door Motor





RR-Door Motor





INSPECTION PROCEDURE

PROCEDURE

1. PERFORM INITIALIZATION (APPLICABLE LOCATION)

(a) Initialize the power window regulator motor Initialization.

NEXT -- Continue to next step.

2. CHECK DTC OUTPUT

(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2313 is not output

Result





B -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH Removal

C -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal

D -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH Removal

E -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal

A -- END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)