Installation

POWER STEERING: DC / DC CONVERTER: INSTALLATION

INSTALLATION

1. INSTALL POWER STEERING CONVERTER ASSEMBLY






(a) Install the converter with the 4 nuts.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)






(b) Connect the 4 connectors, install the clamp on the vehicle front side, and install the nut.
Torque: 8.0 Nm (82 kgf-cm, 71 in-lbf)
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

4. INSTALL REAR FLOOR FINISH PLATE

5. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

6. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler) Installation

7. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

8. INSTALL DECK TRIM SIDE BOARD RH

9. INSTALL ROPE HOOK ASSEMBLY

10. INSTALL ROPE HOOK

11. INSTALL SERVICE PLUG GRIP
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

13. INSTALL BATTERY SERVICE HOLE COVER LH

14. INSTALL BATTERY CARRIER Installation

15. INSTALL BATTERY Installation

16. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY