Installation

SUSPENSION CONTROL: REAR ACTIVE STABILIZER CONTROL ECU: INSTALLATION

INSTALLATION

1. INSTALL REAR ACTIVE STABILIZER CONTROL ECU






(a) Connect the ECU connector.
(1) Connect the ECU connector. (*1)
(2) Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)
(3) Lock the lever's lock. (*3)






(b) Install the ECU with the 2 bolts.
Torque: 14 Nm (138 kgf-cm, 10 ft-lbf)
2. CONNECT REAR ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR






(a) Connect the actuator connector labeled A.
(b) Connect the actuator connector labeled B.
(1) Connect the actuator connector. (*1)
(2) Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)
(3) Lock the lever's lock. (*3)






(c) Attach the wire harness clamp.
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

4. INSTALL REAR FLOOR FINISH PLATE

5. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

6. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

7. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler) Installation

8. INSTALL ROPE HOOK ASSEMBLY

9. INSTALL ROPE HOOK

10. INSTALL SERVICE PLUG GRIP Installation

11. INSTALL BATTERY SERVICE HOLE COVER

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 Nm (57 kgf-cm, 50 in-lbf)
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

13. INSTALL BATTERY SERVICE HOLE COVER LH Battery

14. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

15. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.