Installation

L110F HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU: INSTALLATION

INSTALLATION

1. INSTALL ECU BRACKET





(a) Install the 2 ECU brackets with the 4 screws.
Torque: 3.0 Nm (31 kgf-cm, 27in-lbf)
2. INSTALL HYBRID VEHICLE CONTROL ECU





(a) Install the hybrid vehicle control ECU with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49in-lbf)
(b) Connect the 4 hybrid vehicle control ECU connectors.
3. INSTALL ENGINE ROOM ECU COVER Installation
4. INSTALL ENGINE ROOM SIDE COVER LH Installation
5. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
Some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. INSTALL BATTERY SERVICE HOLE COVER LH Installation
8. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation
9. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
10. RESET MEMORY
(a) If the hybrid vehicle control ECU is replaced, initialize the learning value of the automatic transmission Programming and Relearning.