Removal

2UR-FSE IGNITION: IGNITION COIL AND SPARK PLUG: REMOVAL

REMOVAL
NOTICE:
While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE BATTERY SERVICE HOLE COVER LH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE BATTERY SERVICE HOLE COVER Removal
5. REMOVE SERVICE PLUG GRIP Removal
6. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
7. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal
8. REMOVE ENGINE ROOM SIDE COVER RH Removal
9. REMOVE ENGINE ROOM SIDE COVER LH Removal
10. REMOVE NO. 1 AIR CLEANER INLET Removal
11. REMOVE INTAKE AIR CONNECTOR PIPE Removal
12. REMOVE AIR CLEANER ASSEMBLY LH Removal
13. REMOVE AIR CLEANER ASSEMBLY RH Removal
14. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
15. REMOVE MOTOR CABLE COVER RH Removal
16. REMOVE INVERTER COVER ASSEMBLY Removal
17. REMOVE CONNECTOR COVER ASSEMBLY Removal
18. CHECK TERMINAL VOLTAGE Removal
19. INSTALL CONNECTOR COVER ASSEMBLY Installation
20. REMOVE INVERTER TERMINAL COVER Removal
21. DISCONNECT MOTOR CABLE Removal
22. DISCONNECT GENERATOR CABLE Removal
23. DISCONNECT INLET INVERTER COOLING PIPE





(a) Remove the 2 bolts and disconnect the inlet inverter cooling pipe.
24. DISCONNECT FRAME WIRE
(a) Remove the No. 1 relay block cover.





(b) Remove the 2 nuts from the No. 1 relay block.
(c) Detach the 2 claws to disconnect the frame wire from the No. 1 relay block.
25. DISCONNECT NO. 1 MOTOR COOLING PIPE Removal
26. REMOVE SKID CONTROL ECU Removal
27. DISCONNECT NO. 3 RELAY BLOCK Removal
28. DISCONNECT BRAKE FLUID RESERVOIR Removal
29. REMOVE SKID CONTROL ECU BRACKET Removal
30. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE Removal
31. REMOVE ENGINE COVER SUB-ASSEMBLY RH Removal
32. REMOVE NO. 5 COVER SUB-ASSEMBLY
33. REMOVE ENGINE COVER SUB-ASSEMBLY LH Removal
34. REMOVE NO. 6 COVER SUB-ASSEMBLY
35. REMOVE IGNITION COIL ASSEMBLY
(a) Disconnect the 8 ignition coil connectors.





(b) Remove the 8 bolts.





(c) Using a screwdriver, pry at the cutouts to remove the 8 ignition coils together with the 8 spark plug tube gaskets.
NOTICE:
Do not damage the cylinder head cover when removing the spark plug tube gasket.
HINT: Tape the screwdriver tip before use.

36. REMOVE SPARK PLUG





(a) Using a 16 mm plug wrench, remove the 8 spark plugs.