Installation

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY





(a) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Attach the clip to install the driver side knee airbag.
(c) Install the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
(d) Attach the claw to install the lock lever.
(e) Install the control cable.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Installation
4. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING Installation
5. INSTALL INSTRUMENT SIDE PANEL LH Installation
6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL BATTERY SERVICE HOLE COVER LH Installation
9. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation
10. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
11. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Initialization.