Installation

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: INSTALLATION

INSTALLATION

1. INSTALL STEERING PAD





(a) Support the steering pad with one hand.
(b) Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(c) Connect the horn connector.
(d) Confirm that the circumference groove of the "TORX" screw fits in the screw case, and place the steering pad onto the steering wheel.
(e) Using a T30 "TORX" socket wrench, tighten the 2 "TORX" screws.
Torque: 8.8 Nm (90 kgf-cm, 78in-lbf)
2. INSTALL SWITCH AND VOLUME CASE





(a) Attach the claw to install the switch.
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER





(a) Attach the 2 claws to install the cover.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSTALL BATTERY SERVICE HOLE COVER LH Installation
6. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation
7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
8. INSPECT STEERING PAD
(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
(b) Make sure that the horn sounds.
HINT: If the horn does not sound, inspect the horn system.

9. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.