Installation

ENGINE IMMOBILIZER: CERTIFICATION ECU: INSTALLATION

1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

(a) Install the certification ECU (smart key ECU assembly) with the 2 nuts.





(b) Connect the 2 connectors.

(c) Engage the 2 clamps and connector holder as shown in the illustration.





(d) Install the certification ECU (smart key ECU assembly) together with the instrument panel wire with the bolt and 2 nuts.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

2. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation

3. INSTALL LOWER INSTRUMENT PANEL RH Installation

4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

5. INSTALL SIDE INSTRUMENT PANEL RH Installation

6. INSTALL FRONT DOOR OPENING TRIM COVER RH

HINT
Use the same procedure for the RH side and LH side Installation.

7. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure for the RH side and LH side Installation.

8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSPECT FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Front Passenger Side Knee Airbag Assembly

11. INSPECT SRS WARNING LIGHT

Diagnosis System

12. REGISTER ECU COMMUNICATION ID

NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform initialization Registration.

13. REGISTER KEY

NOTICE:
When replacing the certification ECU (smart key ECU assembly), perform initialization Registration.