Installation

LIGHTING: STOP LIGHT SWITCH: INSTALLATION

1. INSTALL STOP LIGHT SWITCH ASSEMBLY

(a) Insert the stop light switch assembly until the body hits the cushion.





NOTICE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

(b) Make a quarter turn clockwise to install the stop light switch assembly.





Torque : 1.5 Nm (15 kgf-cm, 13 in-lbf) or less

NOTICE:
When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

(c) Connect the stop light switch connector to the stop light switch assembly.





(d) Check the protrusion of the rod On-Vehicle Inspection.

2. INSTALL COMBINATION METER ASSEMBLY Installation

3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation

5. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

7. INSTALL SIDE INSTRUMENT PANEL LH Installation

8. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

9. INSTALL FRONT DOOR SCUFF PLATE LH Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT SRS WARNING LIGHT

Diagnosis System.

12. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.