Removal

AA80E AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL SWITCH: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal

3. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH Removal

4. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Removal

5. REMOVE CONSOLE PANEL SUB-ASSEMBLY Removal

6. REMOVE INSTRUMENT PANEL BOX ASSEMBLY (w/o Ashtray) Removal

7. REMOVE FRONT ASH RECEPTACLE BOX SUB-ASSEMBLY (w/ Ashtray) Removal

8. REMOVE REAR ASH RECEPTACLE ASSEMBLY (w/ Ashtray) Removal

9. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/o Ashtray) Removal

10. REMOVE CONSOLE BOX REGISTER ASSEMBLY (w/ Ashtray) Removal

11. REMOVE CONSOLE BOX Removal

12. REMOVE NO. 2 CONSOLE BOX DUCT Removal

13. REMOVE NO. 2 FLOOR UNDER COVER Removal

14. REMOVE NO. 1 FLOOR UNDER COVER Removal

15. REMOVE TAIL EXHAUST PIPE ASSEMBLY Removal

16. REMOVE REAR NO. 1 FLOOR PANEL BRACE Removal

17. REMOVE FRONT CENTER FLOOR BRACE Removal

18. DISCONNECT HEATED OXYGEN SENSOR Removal

19. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

20. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR Removal

21. REMOVE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal

22. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY Removal

23. REMOVE TRANSMISSION CONTROL SWITCH

(a) Remove the transmission control switch connector from the floor shift assembly.





(b) Remove the shift lever support and lock pin from the floor shift assembly.





(c) Remove the shift lever guide housing from the floor shift assembly.

NOTICE:
First remove the shift lever nut and lock pin, then disengage the 2 claws.

(d) Remove the transmission control switch from the shift lever guide housing.