Installation

POWER DISTRIBUTION: POWER MANAGEMENT CONTROL ECU: INSTALLATION

1. INSTALL POWER MANAGEMENT CONTROL ECU

(a) Engage the 2 claws to install the power management control ECU as shown in the illustration.





2. INSTALL ECU INTEGRATION BOX RH

(a) Install the ECU integration box RH with the 2 nuts and bolt.

(b) Engage the clamp to connect the wire harness.

(c) Connect each connector.

3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Installation

5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

6. INSTALL INSTRUMENT SIDE PANEL RH Installation

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT
Use the same procedure as for the LH side Installation.

8. INSTALL FRONT DOOR SCUFF PLATE RH

HINT
Use the same procedure as for the LH side Installation.

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE Installation

11. INSTALL DECK FLOOR BOX RH Installation

12. INSTALL REAR NO. 3 FLOOR BOARD Installation

13. INSTALL REAR DECK FLOOR BOX Installation

14. INSTALL REAR NO. 2 FLOOR BOARD Installation

15. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform diagnostic system check Reading and Clearing Diagnostic Trouble Codes.

16. INSPECT SRS WARNING LIGHT

Diagnosis System